Mixer machine for CLC block making

The mixer machine for CLC block making, also known as the foam generator, is a mixer machine for CLC block making that makes the foaming agent reach a certain concentration of aqueous solution.

Before starting the mixer machine for CLC block making, the following preparations are required:
1. After the mixer machine for CLC block making arrives at the work site, the installation should be stable. The layout of the conveying pipeline should be as short and straight as possible, with few turns or big turns, no air leakage at the pipe joints, vertical pipes must be fixed, and all pipes must not be stepped on.
2. Check whether the power supply, motor, and electric control box of the lightweight mixer machine for CLC block making are leaking, loose or short-circuited, whether the grounding is intact, and whether the insulation performance meets the requirements. Check whether the rotation of each motor is correct.
3. Check whether the air compressor is short of oil, whether the medicine pump is short of oil, and whether the reducer is short of gear oil. Whether the oil and lubricating oil of the belt conveyor and mixer are sufficient, etc. Check if there is water in the fuel tank.
4. Check whether there is grease on the extrusion tube of the foam concrete machine filled with lightweight concrete
5. The wiring connection is correct to ensure that the air tank of the mixer machine for CLC block making is free of water.

foam concrete machine

Precautions:
First of all, the motor of the mixer machine for CLC block making works for a long time, and it is easy to heat up too high, causing the motor to burn out. Therefore, when themixer machine for CLC block making works for a long time, attention should be paid to cooling down in time. If you find that the motor is overheating, you can open the door of the mixer machine for CLC block making and let it ventilate naturally. Or use electric fans and blowers to cool the motor. Or remove the shell next to the motor to increase its heat dissipation capacity. If you take these measures and still cannot cool well, you should consider temporarily stopping foaming.
Second, minimize the vibration of the mixer machine for CLC block making, which will have a destructive effect on the already formed foam. At the same time, excessive vibration can damage the instruments installed on the machine.

Foam generator for concrete
Third, if the mixer machine for CLC block making leaks, it is usually caused by the foaming agent inlet pipe or valve. The leakage of the mixer machine for CLC block making can easily cause the waste of foaming liquid and affect the quality of the foam. Therefore, once the liquid leaks, you should stop the machine immediately for inspection, find out the leaking part, and deal with it as soon as possible.
Fourth, if you encounter a machine failure or other reasons that cause the machine to not work for a long time during the construction process, you should pay attention to clearing the cement slurry problem in the mixer and pipeline. The treatment method of foam concrete slurry in foam cement pipeline is to connect the water pipe with the machine pipe with a water pump, and the water pumped out by the water pump can clean the foam concrete slurry in the equipment pipe.
We are a professional manufacturer of mixer machine for CLC block making. Our mixer machine for CLC block making have been exported to many countries, not only because of their low prices, but also their good performance. If you have any needs, please feel free to contact us.